You will need :

A Spray Bottle with Soapy water

A Squeegee- A Bondo spreader works well

Paper Towel

Vinyl Graphic

 

Completely clean the surface where the decal will be applied. Test fit the area where you want to apply the decal. Using the spray bottle with soapy water, wet the area where you are going to apply the sticker, making sure there are no dry areas. Peel the backing off to expose the adhesive side of the vinyl graphic. Lightly spray with the soap and water mixture. Do not peel the top layer off yet. Put the sticky side of the graphic to the surface of the car where you want it applied. Slide the graphic around gently to make any adjustments until it is properly place in th area you selected. Using the squeegee work all the fluid and bubbles from the vinyl starting at the center and working your way to the edges. Repeat the process a couple of times if necessary to get all the soapy water and trapped air from underneath the vinyl graphic. With the vinyl graphic on the vehicle spray the entire sticker to neutralize the glue. Squeegee it again to remove any remaining air pockets. The decal need to remain on the vehicle for about 10 minutes before trying to peel off the transfer tape.Once it has dried remove the transfer tape by peeling the tape straight up. If there are any remaining bubbles prick with a needle and then squeegee.